A more convenient/ergonomic layout for the Gameboy link port. The schematic works well inside the Gameboy, but out inside a Super Gameboy.
Im just putting the diodes, caps and resistors in the board to see if I can rearrange them better. So far, I have found a better layout, but can't put it into an SGB until I go home tomorrow.![]()
I've decided the A600 is going again.![]()
*If my post was helpful, click the star in the lower left corner of it to say "Thanks".
*My username will unlock my uploads, if a password is needed.
*Games, Guitars, or Girls... choose any two.
"The New Hangout: Insert In-Your-End-O"![]()
*If my post was helpful, click the star in the lower left corner of it to say "Thanks".
*My username will unlock my uploads, if a password is needed.
*Games, Guitars, or Girls... choose any two.
Yeah it works, and for good reason too. the SGB and GB are the same thing internally. Obviously some things like buttons, speaker and screen have been removed, but the CPU is one in the same (except that the SGB runs at a slightly higher frequency). All of the pins are there, just waiting for me to solder to.
Later I might add an LCD just becuase I can.
Pictures will surely follow.