ePSXe controls suddenly not working !!

[BlackCitadel]

I have got a problem with all the versions of ePSXe suddenly, the controls is not working. I was using a Logitek Joystick, but even when I set the Controllers settings to Default which is using the Keyboard in case it's the Joystick issue but strange because it is working normally with psx_1.13.

What is THAT problem?!

Damn i don't want to format Windows. I have formatted it millions of times. And I kinda lazy to install a new one, I will also lose the installed programs.

[Mohit]

Instead of reinstalling windows try deleting epsxe's registy entries.

[BlackCitadel]

How can I do that?

[Zorlon]

regedit not sure you should do anything in the reg though, you can do more harm than good if you don't know what you are looking at

[BlackCitadel]

But what is that problem and why did it happen all of a sudden?

[Zorlon]

Because I don't want to see you make your machine any worse, just download what I attached to this post extract it and double click it, you will then need to run ePSXe and it will make you config it again from scratch

EDIT no idea why it happened I would only know if I was the one it happened to as it is it happend on a mchine I have never used

P.S. It is not something that happens normally, infact your the first I have seen say it has happend to them

[Mohit]

Because I don't want to see you make your machine any worse, just download what I attached to this post extract it and double click it, you will then need to run ePSXe and it will make you config it again from scratch

EDIT no idea why it happened I would only know if I was the one it happened to as it is it happend on a mchine I have never used

P.S. It is not something that happens normally, infact your the first I have seen say it has happend to them

Someday he will need to learn. It's not that hard.
I forgotten everything because i haven't used my pc for months now.
Open registry editor then go to.
HKEY_CURRENT_USER\Software \epsxe
Then delete it.
Caution : Don't delete other registries. This may lead to a Windows reinstall.

[BlackCitadel]

I am the first one to see it happens because I have always having bad luck on everything.

[Mohit]

You are not the first one.
I seen someone with the same problem but not in this forums.

[BlackCitadel]

Thanks did that and worked now.

[skullpoker]

Typically when a controller stops working, you can fix by pressing F5. If it happens again, try this. F5 toggles analog/digital controller mode in ePSXe.